| Image | Part code |
 |
B1 |
 |
B2 |
 |
DS4 with internal thread |
 |
Threaded pin, M5 x 120 |
| 3,5 x 16 – 4 units | A2 S/St screws |
- You should have fitted Air-Only ventilator!
- Threaded pin requires cutting to length prior to assembly.
- Screw threaded pin into DS4 from the Breezy set and replace existing.
- Refit o-ring.
- Screw handle B2 to pin. Measure A as shown on Picture 1:
- Unscrew pin and cut (Amm-50mm).
- Fit DS4, pin and B2. You will get result as shown on Picture 2:
- Trial fit B1. Using B1 as template mark places for screws.
- Check motor and on-board voltage.
- Complete assembly by connecting electricity to the motor (Red wire [+], black wire [-]) and fitting B1 as shown on Picture 3:
